The “Settings” section: различия между версиями

Материал из База знаний VINTEO
 
(не показана 1 промежуточная версия этого же участника)
(нет различий)

Текущая версия на 15:27, 2 сентября 2024

GUI Terminal 18

This section is to access the followed settings menu:

  • System Status;
  • Main Settings;
  • System Settings.

The “System status” menu

GUI Terminal 19

System

The page with information about the system: manufacturer, model, version, software version, serial number, system name, SKU Number, line, terminal operating time, telephony operating time, number of licenses. The terminal operating time and telephony operating time are dynamically updated on the page.

Network

The page with information about the network status: IP address, mask, gateway, MAC address, network status, data transfer speed, duplex mode.

Camera

The page with information about connected cameras.

Microphone

The page with information about connected microphones.

SIP/H.323

The page with information about SIP and H.323 parameters: protocol enable, registration enable, registration address, registration name, registration status.

Diagnostics

Ping

The page for checking the integrity and quality of connections in TCP/IP-based networks. By default the destination address is the network gateway address (Gateway).

To initiate a request:

  1. move focus to the “Ping IP” field
  2. press the OK control button (19) – the result will be displayed in the terminal window.

To change the destination address:

  1. move focus to the field with the address (10.1.1.1 or other);
  2. press the OK control button (19) – the page with the input module [Appendix A] will open;
  3. enter the required destination address (example: 10.1.1.10);
  4. save the entered data: return to the parent page; the result will be displayed in the terminal window.

To view the diagnostic result:

  1. move focus to the field with the terminal window;
  2. press the OK control button (19) – the terminal window will change color;
  3. use the “Up” (4) and “Down” (7) control buttons to move the lines for viewing;
  4. exit the terminal window viewing mode using the OK (19) or “Back” (8) control buttons.

Trace

The page for defining data routes in TCP/IP networks. The steps are the same as those described on the Ping page.

GUI Terminal 20